![]() ![]() The felt from the second panel will fit behind the last slat of the first panel, completely hiding the seam from view and allowing you to install endless panels next to each other to make one, uniform accent or feature wall. The tongue and groove pattern of the felt and the slats will allow you to fit each panel side-by-side while maintaining the uniformity in spacing between slats. We recommend a total of 6-8 screws per panel, spaced evenly around the edges and closer to the middle of each panel, as shown.įit the second panel next to the one you just installed and repeat this process. Once all anchors have been installed and/or studs have been located, put the first panel back in place and insert the screws. ![]() NOTE: If you’re mounting into drywall only, be sure to insert the appropriate anchors before drilling. Whichever you decide, measuring your space and even holding your panels in different places will help you finalize your mounting locations. Some people center the panels on their wall for a framed look, while others install them flush with the floor for a more grounded aesthetic. To start, measure your space and decide where you’re going to install the panels. 12-16 Screws (black recommended, 1 ½ inch in length).Installing Willow Panels out of the box is a breeze.
0 Comments
Leave a Reply. |